Aidite CSF-400 Support

Aidite CSF-400 Customer Onboarding & Technical Support

Congratulations on your new Aidite CSF-400 Fast Sintering Furnace.

Use the resources below to unpack, install, calibrate, and begin operating your furnace correctly. Review all applicable instructions before running your first sintering cycle.

Before You Begin

Confirm that the installation location, electrical supply, ventilation, and surrounding clearance meet the manufacturer’s requirements before connecting the furnace.

Use only validated sintering programs for the specific zirconia material, restoration type, and case configuration being processed. Rapid-sintering times are material- and case-specific and should not be applied universally.

1

Unpacking and Calibration

Watch this video before operating the furnace. It covers the initial unpacking and calibration process.

2

CSF-400 User Guide

Review the operating controls, program selection, loading procedures, and routine use of the CSF-400.

Initial Setup Checklist

  • Inspect the furnace and accessories for shipping damage.
  • Place the furnace on a stable, heat-resistant surface.
  • Confirm the required electrical connection before powering on the unit.
  • Maintain the manufacturer-required clearance around the furnace.
  • Complete the applicable calibration procedure.
  • Confirm that the correct sintering tray and accessories are installed.
  • Select the validated program for the zirconia being processed.
  • Do not begin production until setup and calibration have been completed successfully.

Sintering Program Guidance

The CSF-400 may be used with different Aidite zirconia materials, but the appropriate program depends on the material and restoration type.

Do not assume that a rapid program validated for an AiZir Flash single crown is appropriate for bridges, full-arch restorations, thicker restorations, or other zirconia materials. Always follow the current material-specific instructions for use.

CSF-400 Downloads

Download the product brochure for published specifications and general product information.

Download CSF-400 Brochure

Need Technical Support?

Before contacting support, record the furnace serial number, software or firmware version, selected program, zirconia material, restoration type, and any error message shown on the display.

Photos or a short video of the furnace display and the issue can help accelerate troubleshooting.